A number of people start to get anxious once the holiday feel kicks in with them installing some Christmas lights around the home. This task is usually done towards the end which is a bit unfortunate. This is actually quite sad for anyone in the holiday spirit to comprehend. It really does not have to be responsibility on your part to abide. This is one lucky day for you, as this read would give you the much needed advice in order to give the holidays the best atmosphere. Take note that everything stated here is coming from a professional who knows his ways in the light installation market.
Firstly, what is highly recommended for you to use during your stapling phase would be a wire tacker instead of the average stapler. The protective coating may be affected with the use of the normal staples. The typical ones have a more valid tendency to damage the wires which could active a short circuit in the system. U-shaped staples are being used in wire tackers, and they only leave a small portion for the cable wire. This is to make sure that the wires stays in pristine condition. What is advised for you to do is to staple one inch of the wire from the different sides of the light. This is to make sure that the lights would stand and look consistent from the outside. Everything is kept clean with this kind of tip that you are considering.
The best thing to do when it comes to stringing those lights on the roof would have you check the perimeter of the building for the installation. Again, you would have a much clean appearance on your building’s facade.
Non-invasive clips may be good for you to utilize if you do not want to have some prevalent staple marks showing. These clips are rather cheap and easy, and they could conveniently be secured unto those shingles or gutters. Just keep in mind that you need one for every light bulb there is.
Installations Tips for The Average Joe
As much as possible, do not hang those lights facing upward or even staple them for that matter. If there is rain, then water could very much penetrate the light. A good advice for you to keep in mind is to have them point down or out the premise.
To be sure of potential malfunctioning, use an electrical tape to seal both end plugs between strands. Again, water may be a strong culprit for such lights to go off, which could ruin your holiday spirit and cheer in the process.
If you are really busy with those preparations, then why not call for a professional then? In this way, you could get the best of your investment in the long run.
Have a good holiday!